• Hi there to guys that have converted to Mikuni vm32 carbs could you tell me if...

    Hi there,to guys that have converted to Mikuni vm32 carbs could you tell me if your throttle slides are #3.0 or 3.5? The reason is I'm planning on switching to 3.5 cut cause I cant tune my fuel air mixture(too rich),have different pilots and main jets,needle position to no avail.Thanks!

    10 comments
    • www.mikuni.com › pdf › vmmanual

    • I have the manual,the only thing I haven't done is change needle jet !

    • I read in a 60's honda manual to switch to wider cut away throttle slide if pilot jet is not helping!

    • I was trying to fix a problem with jets that isn't carb related lol still looking.

      As for the jetting, I ordered a pre jetted mikuni set from dime city cycles. They cam with 185 Main, 35 Pilot, 6DH7 Jet Needle, 2.0 Air Jet, 159 P-5 Needle Jet

    • You guys sharing jetting information really need to include your height above sea level.

    • St louis Missouri... I have no idea the altitude lol

    • I'm in So Cal. I got up to 210 on the mains on a day that was almost 100 degrees so I'm sure I'll have a little more tuning to do. But it sure runs great now!

    • I got from 185-210. Figured that'd be a good spread

    • Might be worth trying to add any manuals to our file section?