How easy is it to swap over the handle bars esp with everything attached is the...

How easy is it to swap over the handle bars esp with everything attached is the any modding i would have to do?

10 comments
  • You will have to drill a 5.5 mm hole in each side for the throttle body and the electrics on the left side and depending how wide the bars are you might have to reroute the clutch cable.

  • So is it easy to do or a pin in the arse youtube videos make it look too easy

  • Most do that, but I didn't drill any holes. I just filed off the "nub" on the controls and fitted some electrical tape under the controls.

  • What is the reason for drilling the holes though i dont get it(i know stupid question but u learn from asking)

  • It's because there are little nubs on the controls. If the bar has no holes then the controls wont fit on properly.

  • So its just so they are held in place then

  • Cheers mate

  • No problem.

  • Drilling the holes is easy mate i actually used the bar clamps on my bike and the vice to hold them while i drilled the holes. Just use a new/sharp drill piece about 2mm to start the hole off and its easy to do.