• question

    Would any one no why with my cbr1000f 91

    I can't change gear from 2 nd to 3rd very easy I've got to rev it up to change also same changing down only seems to be these two gears

    Would any one no why with my cbr1000f 91

    I can't change gear from 2 nd to 3rd very easy I've got to rev it up to change also same changing down only seems to be these two gears

    12 comments
    • A little more Bite, but not savage. Clutch is a little more heavier to use as came with heavier springs. Had to upgrade after changed exhaust system and air filer. Gave a little more BHP as was to much for the clutch on the Bike.

      As was planning to do more performance upgrade. Just made sense to me to get the Race/Street clutch with high ratted springs

    • Ps :)

      Being stopped at traffic lights can get heavy, Normally change in to Neutral

    • i best start weight training so i can change gears lol

    • So update went into garage last night with bike turned off every gear can be selected fine however gear leaver doesn't bounce back it just stays there is there a internal spring that bounces it back

    • There is a spring, But not heard many go. Is it easy to return back to postion, or dose it take some force. A little worried now about selector

    • It is easy to select gears when switched off just doesn't spring back

    • return spring as snapped

    • by the sounds of it.

    • Index spring needs replacing, sooner rather than later. as if has snapped. Then need to get out it and the peice that has snapped off

    • or shifter spring

    • Did say on a forum about shifter spring can sometimes stick. with a build up of dirt.

      So may not be a major job