• What could be wrong

    What could be wrong?

    52 comments
    • Sounds like your through shaft is messed up

    • Can be ring gear and pinion

    • Clutches

    • ^^^^that too

    • This hurts my heart

    • Sounds like it time for a new rear ending

    • We're going to check clutch next, took front diff and skooted it foreword and still did it so next clutch then rearend

    • my 2wd did that and it was the ring and pinion

    • Zach Sims

    • It's not coming from rear end it's defiantly in the motor just wandering what u guys thought about could it be the clutch? Or transmission gears?

    • Exactly

    • Can you explain what that is I disconnected front driveshaft to make sure it wasn't stripping on the splines

    • Hoping so but what would make the clutches sound like that?

    • The through shaft is what connects both diffs together (it's the shaft that goes through the motor)

    • I'm asking I know it's eather one it's my bike just had my buddy post it up for me

    • Ok I see, would that meen splitting the cases?

    • Yeahs

    • Yes

    • Balls!

    • for sure in something in tranny

    • I'd check the tranny

    • Yea that sucks this thing runs to strong to be stripping motor apart

    • Any possibility it could be my clutches?

    • Anthony Carter can tell you

    • He's a Honda pro

    • Lol thank ya

    • No problem

    • I learned everything I know from him

    • Sounds bad hard to say with it not at my shop

    • I understand that, would u think there's any possibility that the clutches would make that noise

    • Sound line spline slippage

      350 rancher ?

    • Yes

    • They have a small shat that goes through the clutch cover I believe that will be your problem

    • Two piece threw shafts

    • If that's the problem than I wouldn't have to split cases, I'm going to pm you I'm so built throu the week with work and collage it will be this weekend before I start on it agian I am going to take the front cover off and send you some pics in your pm thanks for the info

    • I also have another question we also have another rancher that is getting no fire, replaced coil and cdi box already still no spark any pointers on that.

    • Austin Michael Hail

    • Yea my bike is doing that.

    • Replaced wiring harness new fuses

    • Ohm the stator

    • Crapp.

    • Zach Sims think I'm going to take everything off my bike. Buy axles and lift it and swap frames and all.. and rebuild motor while at it

    • U just rebuilt the motor lol, what other frame u gonna use

    • Buy a service manual and test the stator

    • Zach Sims I have a brand new powder coated one

    • I didn't kno that

    • Yessir

    • Gonna put new seals and all

    • If it's an automatic or a es it could be clutches or transmission. Just got my 420 in the shop and they checking to see what it is rn.

    • It's manual shift but noise is coming from motor

    • Did you run it low in oil

    • Little bit but no smoke it's got oil on it now